KEEP SURFACE CLEAN AND DRY TO REDUCE POSSIBILITY OF SLIP-FALL ACCIDENTS. READ PRODUCT DIRECTIONS THOROUGHLY PRIOR TO USE. The actual removal requirements may vary depending on type of tile, method of application and amount of stains to be removed. This recommendation is intended as a general guideline for the removal of deep-set stains from porous tile, natural stone and masonry. When a Aqua Mix® Poultice Stain Remover and water mixture does not effectively remove the stain, the following recommended AQUA MIX products used in conjunction with Poultice in a mixture have been Note B: Sealer & Coating Remover will remove sealers and wax-type coatings. Note A: Do not use on synthetic agglomerate or other resinous surfaces. Wipe surface dry with clean, absorbent, white cotton towels. All grout is a porous, and stains instantly. Wipe up residue with absorbent white cotton towels.Ĩ. Serious, permanent damage can be caused to tiles and grout by using the wrong products Stained, dirty floor grout. If necessary, apply additional remover or sprinkle with hot water and agitate with a scrub brush or white nylon pad.Ħ. Allow to stand up to 1 hour, not allowing Sealer & Coating Remover to dry on surface.ĥ. Apply a liberal amount of undiluted Sealer & Coating Remover over stain(s).Ĥ. Always test a small area first to ensure satisfactory results.ģ. Product Recommendation: Sealer & Coating Remover (Notes A & B)Įquipment: Scrub brush or white nylon pad and white cotton towelsġ. Purpose: To remove stains that have penetrated into tile or stone surfaces If area darkens from absorbed moisture, it should dry completely within 2 to 4 days. If poultice paste has not dried, allow to dry uncovered before removal.ħ. Remove Poultice Stain Remover without scratching surface with a plastic putty knife and wash off residue with clean water and sponge. Allow paste to stand on stain for 24 to 48 hours.Ħ. Leave a small section untaped or punch holes in plastic wrap to allow for slow curing.ĥ. Cover with household plastic wrap, taping around perimeter to seal over Poultice Stain Remover mix. Apply a 1/4″ (6 mm) thick layer of paste directly over stain with at least a 1″ (25 mm) overlap beyond edge of stain.Ĥ. Mix several tablespoons of Poultice Stain Remover powder with water in a bowl to form a thick, pliable paste.ģ. Product Recommendation: Poultice Stain RemoverĮquipment: Bowl, household plastic wrap, plastic putty knife and spongeĬoverage: Varies test first to determine amount of product needed depending on number of stains present Procedure:Ģ.
![porus tile porus tile](https://ars.els-cdn.com/content/image/1-s2.0-S0955221910005479-gr5.jpg)
![porus tile porus tile](https://www.cleanlink.com/resources/editorial/2017/tile-grout-52014.jpg)
#PORUS TILE HOW TO#
Printable version: How to remove remove of Deep-Set Stains from Porous Tile/Natural Stone/Masonry Method A